Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Pinpoint Test Purpose
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
To verify PSCM U2101 is present and provide diagnostics if DTC U2101 is currently present and active in the PSCM.
- BS1: CHECK VEHICLE HISTORY
- BS2: CONFIGURE THE IPC
- Ignition ON, engine OFF.
- Using a diagnostic scan tool, configure the IPC. Refer to MODULE CONFIGURATION SYSTEM .
- Ignition OFF.
- Ignition ON, engine OFF.
- Clear the PSCM DTCs.
- Ignition OFF.
- Wait at least 90 seconds for the modules to completely shut off.
- Ignition ON, engine OFF.
- Carry out the PSCM self-test.
- Does DTC U2100 return?
Yes No INSTALL a new EPAS steering column.
REFER to STEERING COLUMN .
ORDER a replacement EPAS column and INCLUDE the RVC on the order form.
If this is a Ford paid repair, INCLUDE the RVC on the warranty claim.The condition causing the DTC is not present at this time.
- BS3: CONFIGURE THE BCM
- Ignition ON, engine OFF.
- Using a diagnostic scan tool, configure the BCM. Refer to MODULE CONFIGURATION SYSTEM .
- Ignition OFF.
- Ignition ON, engine OFF.
- Clear the PSCM DTCs.
- Ignition OFF.
- Wait at least 90 seconds for the modules to completely shut off.
- Ignition ON, engine OFF.
- Carry out the PSCM self-test.
- Does DTC U2100 return?
Yes No INSTALL a new EPAS gear.
REFER to POWER STEERING SYSTEM .
ORDER a replacement EPAS gear and INCLUDE the RVC on the order form.
If this is a Ford paid repair, INCLUDE the RVC on the warranty claim.The condition causing the DTC is not present at this time.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
