Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Aids
For DTC U3000:41, the PSCM disables steering assist, enters manual mode and transmits an invalid steering angle message over the HS-CAN. The module also sends a message to the instrument cluster to display POWER STEERING ASSIST FAULT in the message center.
For DTC U3000:49, the presence of this DTC may or may not affect steering assist. It depends on what other DTCs (if any) are set along with U3000:49. Diagnose all other DTCs before diagnosing U3000:49. The module also sends a message to the instrument cluster to display POWER STEERING ASSIST FAULT in the message center.
| Failure | Action |
|---|---|
| 41 | GO to PINPOINT TEST BT |
| 49 | GO to PINPOINT TEST BT |
| 62 | GO to PINPOINT TEST BT |
| 64 | GO to PINPOINT TEST BT |
| 96 | GO to PINPOINT TEST BT |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
