2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE

DTC U0553: Invalid Data Received from Lighting Control Module-Rear "B": Description

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

The PSCM monitors the HS-CAN messages when the ignition has been on for more than 5 seconds, the voltage to the PSCM is greater than 6.5 volts and there are no DTCs present inhibiting PSCM operation.

  • DTC U0553:00 (Invalid Data Received from Lighting Control Module-Rear "B": No Sub Type Information) - This DTC sets if the PSCM receives a value of "unchanged data", "faulty", or "no data exists" in the trailer back up assist message from the RLCM-B.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.