2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE

DTC U0403: Invalid Data Received From Transfer Case Control Module: Description

WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

The PSCM monitors the HS-CAN messages when the ignition has been on for more than 5 seconds, the voltage to the PSCM is greater than 6.5 volts and there are no DTCs present inhibiting PSCM operation.

  • DTC U0403:00 (Invalid Data Received from Transfer Case Control Module: No Sub Type Information) - This DTC sets if the PSCM receives a value of "unknown" for the transfer case range from the TCCM.
  • DTC U0403:29 (Invalid Data Received from Transfer Case Control Module: Signal Invalid) - This DTC sets if the PSCM receives a value of "faulty" or "not available" for the transfer case range from the TCCM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.