Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Cruise Control System: Note
WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
For operation procedures of each component of the cruise control system, refer to the appropriate service information.
- Cruise control unit: < refer to CRUISE CONTROL MODULE . >
- Cruise control command switch: < refer to CRUISE CONTROL COMMAND SWITCH . >
- Combination meter: < refer to COMBINATION METER . >
- Stop light and brake switch: < refer to STOP LIGHT & BRAKE SWITCH . >
- Clutch switch: < refer to CLUTCH SWITCH . >
- Inhibitor switch: < refer to INHIBITOR SWITCH . >
- Transmission control module (TCM): < refer to TRANSMISSION CONTROL MODULE (TCM) . >
- Neutral position switch: < refer to NEUTRAL POSITION SWITCH . >
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
