Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Section 1249 (Rear Climate Control System)
WARNING: This page is about a different car, the 2018 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Rear Climate Control - Component Location
- Rear Climate Control - Overview
- Rear Climate Control - System Operation and Component Description
- System Operation
- Component Description
- Rear Heating, Ventilation and Air Conditioning (RHVAC) Control Module
- Rear Blower Motor
- Rear Blower Motor Speed Control
- Rear Air Discharge Temperature Sensor
- Rear Footwell Air Discharge Temperature Sensor
- Rear Temperature Sensor
- Door Actuator - Rear Air Distribution
- Door Actuator - Rear Temperature
- Rear Heater Core
- Rear Evaporator Core
- Rear Thermostatic Expansion Valve (TXV)
- Removal And Installation
- Rear Air Discharge Temperature Sensor
- Rear Air Distribution Door Actuator
- Rear Blower Motor
- Rear Blower Motor Speed Control
- Rear Climate Control Housing
- Rear Evaporator
- Rear Evaporator Rear Outlet and Inlet Line
- Rear Footwell Air Discharge Temperature Sensor
- Rear Heater Core
- Rear Heater Core Inlet Line
- Rear Heater Core Outlet Line
- Rear Heating, Ventilation and Air Conditioning (RHVAC) Control Module
- Rear Temperature Door Actuator
- Rear Temperature Sensor
- Rear Thermostatic Expansion Valve
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
