Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Rear Peripheral Camera - R246- Calibrating: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration Tool - VAS6350A-
- Peripheral Camera Calibration Device - VAS6350A/6-
- Calibration Tool - R8 Wheel Adapters - VAS6350/5- for rims with a large offset (RS 6)
- Vehicle Diagnostic Tester
The Rear Peripheral Camera - R246- is installed in the rear lid handle button.
- Establish the requirements. Refer to Peripheral Camera System, Calibrating .
- Install and align the -VAS6350A- with - VAS6350A/6-. Refer to Calibration Tool VAS6350A with Peripheral Camera Calibration. .
- Connect the Vehicle Diagnostic Tester.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.