Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE
Component Location Overview - Peripheral Camera
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 2 Nm
- Quantity: 2
- Right Peripheral Camera -R245-/Left Peripheral Camera -R244-
- Removing and installing. Refer to Exterior Rearview Mirror; Overview.
- Calibrating. Refer to Peripheral Camera System, Calibrating . -->
- E-Box
- Peripheral Camera Control Module -J928-
- Connector Assignment. Refer to Wiring diagrams, Troubleshooting & Component locations.
- Removing and installing. Refer to Peripheral Camera Control Module -J928-, Removing and Installing . -->
- Calibrating. Refer to Peripheral Camera System, Calibrating .
- Rear Peripheral Camera -R246-
- Sedan, removing and installing. Refer to Peripheral Camera System, Calibrating .
- Avant, removing and installing. Refer to Rear Peripheral Camera - R246-, Removing and Installing .
- Calibrating. Refer to Peripheral Camera System, Calibrating .
- Nut
- 3 Nm
- Quantity: 2
- Bolt
- 3 Nm
- Quantity: 2
- Front Peripheral Camera - R243-
- Removing and installing. Refer to Peripheral Camera System, Calibrating .
- Calibrating. Refer to Peripheral Camera System, Calibrating .
No Illustration
- Bumper cover end plate screws: 3 Nm
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.