2016 Audi S8 BaseFACTORY OEM SERVICE PROCEDURE

Front Disc Brake Assembly: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a thin coat of Molykote M7439 (Part No. K0770YA000) or grease contained in the pad kit to the support.
    Fig 1: Applying Thin Coat Of Molykote M7439 (Part No. K0770YA000) Or Grease Contained In Pad Kit To Support
    G05662858Courtesy of SUBARU OF AMERICA, INC.
  2. Install the support to the housing.

    Tightening torque:Β 

    80 N.m (8.16 kgf-m, 59.0 ft-lb)Β 

  3. Apply a thin coat of Molykote M7439 (Part No. K0770YA000) or grease contained in the pad kit to the pad clip.
    Fig 2: Applying Thin Coat Of Molykote M7439 (Part No. K0770YA000) Or Grease Contained In Pad Kit To Pad Clip
    G05662848Courtesy of SUBARU OF AMERICA, INC.
  4. Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or grease contained in the pad kit to both surfaces of the pad inner shim.
    Fig 3: Applying Thin Coat Of Molykote AS880N (Part No. K0777YA010) Or Grease Contained In Pad Kit To Both Surfaces Of Pad Inner Shim
    G07666341Courtesy of SUBARU OF AMERICA, INC.
  5. Install the pad to support.
    CAUTION:
    • Be sure to install so that the pad return spring faces the input side of the direction of brake rotor rotation, as shown in the illustration.
    • Correctly install the pad return spring to the supporting surface of the pad clip as shown in the illustration.
    • If the pad return spring is deformed or damaged, replace the brake pad.
      Fig 4: Brake Rotor Rotation System
      G07666342Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.