Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Number/Engine Specifications
Engine Number
The engine number -arrow B- is visible, when the housing for the charge air cooler is removed.
The first 3 digits of the engine code -arrow A- are visible, when the engine cover is removed.
- The engine serial number ("engine code" and "serial number") are located on the front of the cylinder block on the left side -arrow B-.
- Engine codes beginning with "C" are four letters long.
- The first three positions of the engine code stand for displacement and the mechanical engine structure. They are stamped in the cylinder block, including the serial number.
- The fourth position represents the engine output and torque and is dependent on the engine control module.
The four digit engine code is on the type plate (market-specific), vehicle data label and engine control module.
Component locations of the type plate (market-specific) and vehicle data label. Refer to VEHICLE DATA LABEL .
Engine Specifications
Refer to ENGINE OVERVIEW .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
