Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Audi S8FACTORY OEM SERVICE PROCEDURE
7 Special Tools
Special Tools And Workshop Equipment Required
- Track Rod Tool Insert - T40183-
- Torque Wrench 1783 - 2-10Nm - VAG1783-
- Brake Pedal Actuator -VAG1869/2-
- ACC Adjuster - VAS6190/2-
- Calibration Tool - Linear Laser - VAS6350/3- (can be used from the Calibration Tool - VAS6350-)
- Setting Device Basic Set - VAS6430/1-
- ACC Reflector Mirror - Audi - VAS6430/3-
- Night Vision Calibration Tool - VAS6430/6-
- Steering Wheel Scales - VAS6458-
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.