Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2015 Audi S8FACTORY OEM SERVICE PROCEDURE

Windshield Projection Head Up Display Control Module, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S8, 2018 Audi A8 Quattro, 2017 Audi S8, 2017 Audi A8 Quattro, and 2016 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the upper cover. Refer to Overview - Instrument Panel Assembly .

-- Cover the control module -3- with a soft towel.

Fig 1: Identifying Windshield Projection Head Up Display Control Module, Screws And Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the windshield. Refer to Windshield, Removing and Installing .

-- Remove the bolts -1, 2 and 5-.

-- Lift the control module slightly and disconnect the connector -4-.

-- Remove the control module.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.