2015 Audi S8FACTORY OEM SERVICE PROCEDURE

Windshield Projection Head Up Display Control Module, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S8, 2018 Audi A8 Quattro, 2017 Audi S8, 2017 Audi A8 Quattro, and 2016 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Danger of causing damage.

  • Remove only the marked screws from the Windshield Projection Head Up Display Control Module -J898-.
  • The Windshield Projection Head Up Display Control Module -J898- must be replaced if the screws are removed from the housing upper section.
  • If the Windshield Projection Head Up Display Control Module -J898- should fall down, it must be replaced because the inner components will get damaged even though there is no damage on the outside.
  • Do not place any force on the upper section of the Windshield Projection Head Up Display Control Module -J898- housing. Otherwise the Windshield Projection Head Up Display Control Module -J898- will have to be replaced.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.