Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Windshield Projection Head Up Display Control Module -J898
Danger of causing damage.
- Remove only the marked screws from the windshield projection head up display control module.
- The windshield projection head up display control module must be replaced if the screws are removed from the housing upper section.
- The windshield projection head up display control module must be replaced if it falls down because the inner components will get damaged even though there is no damage on the outside.
- Do not place any force on the housing upper section for the windshield projection head up display control module otherwise the windshield projection head up display control module will have to be replaced.
Removal
-- Remove the upper cover. Refer to INSTRUMENT PANEL UPPER COVER, REMOVING AND INSTALLING .
-- Cover the control module -3- with a soft towel.
-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .
-- Remove the screws -1, 2 and 5-.
-- Lift the control module slightly and disconnect the connector -4-.
-- Remove the control module.
Installation
- Tightening specification, refer to WINDSHIELD PROJECTION CONTROL MODULE -J898- OVERVIEW .
Install in reverse order of removal, observing the following:
-- Install the control module and tighten the screws.
-- Mount the windshield and secure it - do not bond it.
-- Turn on the ignition and check the control module function.
- A number must be appear on the windshield.
-- Install the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .
-- Install the upper instrument panel cover. Refer to INSTRUMENT PANEL UPPER COVER, REMOVING AND INSTALLING .
-- Calibrate the windshield projection control module. Refer to WINDSHIELD PROJECTION HEAD UP DISPLAY CONTROL MODULE -J898-, CALIBRATING .
-- Install the windshield projection control module cover. Refer to OVERVIEW - INSTRUMENT PANEL, WINDSHIELD PROJECTION (HEAD UP DISPLAY) .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.