Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Left Peripheral Camera -R244- /Right Peripheral Camera -R245- CALIBRATING
Special tools and workshop equipment required
- Calibration ToolVAS6350
- Peripheral Camera Calibration DeviceVAS6350/6
- Vehicle Diagnostic Tester
The Left Peripheral Camera -R244- /Right Peripheral Camera -R245- are installed inside the left and right exterior mirrors.
The following describes calibrating the Left Peripheral Camera -R244-. Calibrating the Right Peripheral Camera -R245- is identical.
-- Set-up requirements, refer to Calibration Requirements .
-- Install and align the Calibration ToolVAS6350 with Peripheral Camera Calibration Device VAS6350/6, refer to Calibration Tool VAS6350 WITH Peripheral Camera Calibration Device VAS6350/6, INSTALLING AND ALIGNING .
-- Connect Vehicle Diagnostic Tester.
Setting Up the Calibration Device
Attaching the Calibration Tool - Wheel Center MountingsVAS6350/1:
-- Check the dimension of the holes.
-- Equip the Calibration Tool - Wheel Center MountingsVAS6350/1 appropriately. Use spacer pieces.
-- To do this, secure three wheel bolt adapters in the hole circle to the Calibration Tool - Wheel Center MountingsVAS6350/1.
-- Position the paddle on the Calibration Tool - Wheel Center MountingsVAS6350/1 and secure using the clamping screw.
-- Place the Calibration Tool - Wheel Center MountingsVAS6350/1 on the wheel bolts on the left front wheel.
The Calibration Tool - Wheel Center MountingVAS6350/1 is positioned by the "O rings" in the adapters and held in place.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.