2013 Audi A4 BaseFACTORY OEM SERVICE PROCEDURE

Navigation System with CD Drive Control Module -J401-, REMOVING AND INSTALLING. BASIC PLUS: Removing

-- Open the glove compartment.

-- Insert two clips from the Radio Removal Tool T10057 into release slots on Navigation System with CD Drive Control Module -J401- until they engage. Points on the grip eyelets of tool face outward.

Fig 1: Removing Navigation System With CD Drive Control Module
GWWA91-10953Courtesy of AUDI OF AMERICA, LLC

-- Pull Navigation System with CD Drive Control Module -J401- out of mounting frame.

-- Release and disconnect all connectors from the Navigation System with CD Drive Control Module -J401-.

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps VAS6223/9 -1- onto the MOST bus connector -2-.

Fig 2: Identifying Fiber-Optic Repair Set - Connector Protective Cap
GWWA97-0760Courtesy of AUDI OF AMERICA, LLC

-- Remove Radio Removal Tool T10057 by pressing locking tabs on Navigation System with CD Drive Control Module -J401-.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.