Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Audi S4 Standard TransFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G12 (Avant) (11) | Left rear of engine compartment. See Figure. |
| G12 (Sedan) (11) | Left rear of engine compartment. See Figure. |
| G50 (Avant) (9) | Left side of luggage compartment. See Figure. |
| G50 (Sedan) (9) | Left side of luggage compartment. See Figure. |
| G51 (Avant) (6) | Right side of luggage compartment. See Figure. |
| G51 (Sedan) (6) | Right side of luggage compartment. See Figure. |
| G61 (Avant) (8) | Behind left quarterpanel. See Figure. |
| G61 (Sedan) (8) | Left "C" pillar. See Figure. |
| G62 (5) | Right "C" pillar. See Figure. |
| G615 (Avant) (13) | On left front strut tower. See Figure. |
| G615 (Sedan) (13) | On left front strut tower. See Figure. |
| G624 (Avant) (7) | Middle of luggage compartment, near battery. See Figure. |
| G624 (Sedan) (7) | Middle of luggage compartment, near battery. See Figure. |
| G638 (Avant) (2) | Behind right kick panel. See Figure. |
| G638 (Sedan) (2) | Behind right kick panel. See Figure. |
| G639 (Avant) (12) | Behind left kick panel. See Figure. |
| G639 (Sedan) (12) | Behind left kick panel. See Figure. |
| G654 (5) | Top of right "D" pillar. See Figure. |
| G671 (Avant) (14) | On left front long member. See Figure. |
| G671 (Sedan) (14) | On left front long member. See Figure. |
| G685 (Avant) (1) | On right front long member. See Figure. |
| G685 (Sedan) (1) | On right front long member. See Figure. |
| G687 (Avant) (10) | Left side of center tunnel. See Figure. |
| G687 (Sedan) (10) | Left side of center tunnel. See Figure. |
| G688 (Avant) (3) | Right side of center tunnel. See Figure. |
| G688 (Sedan) (3) | Right side of center tunnel. See Figure. |
| G730 (Avant) (4) | Base of right "C" pillar. See Figure. |
| G730 (Sedan) (4) | Base of right "C" pillar. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.