Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Audi S4 Standard TransFACTORY OEM SERVICE PROCEDURE
Engine Assembly (Complete): Remove & Replace
WARNING: This page is about the S4 Automatic DCT Trans, which is a different variant/trim than selected.
Includes: R&I Engine Assembly. Transfer Fuel and Electrical Assemblies and Engine Mounts.
DOES NOT include transfer of Manifolds, Valve Cover(s), Timing Cover(s), Oil Pan and/or Water Pump.
NOTE: For bare Engine, refer to Long Block - R&R.
DOES NOT include wheel alignment (unless noted otherwise).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 21.0 | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.