Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Protection Devices
/Fuse Carrier In plenum chamber electronics box. See Figure. Fuse Panel A On battery, in luggage compartment. See Figure. Fuse Panel (Driver's Side) Behind left end of dash. Fuse Panel (Passenger's Side) Behind right end of dash. Luggage Compartment Relay/Fuse Carrier Right side of luggage compartment. Vehicle Electrical System Control Module W/Relay/Fuse Carrier Behind left side of dash. See Figure. 6-Panel Connector Station A-Pillar (Driver/Passenger Side) Behind respective kick panel. See Figure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.