Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE
Dynamic Steering System Description
- 01 On Board Diagnostic
- Dynamic Steering General Information
- Dynamic Steering Function Description
- Basic Function
- Active Steering Control Module -J792-, FUNCTIONS
- Description And Operation
- Can Data Interchange
- Active Steering Control Module -J792-
- Data Bus On Board Diagnostic Interface -J533-
- Motronic Engine Control Module -J220-
- Comfort System Central Control Module -J393-
- ABS Control Module -J104-
- Steering Angle Sensor -G85-
- ESP Sensor Unit -G419-
- ESP Sensor Unit 2 -G536-
- Vehicle Electrical System Control Module -J519-
- Special System Functions
- Information For Service
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.