2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE

DTC Memory With ODIS, Checking

WARNING:

Warning information for the high voltage system:

Procedures for which the ignition needs to be switched on. Refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .

-- Connect the Vehicle diagnostic tester. Refer to Vehicle Diagnostic Tester, CONNECTING .

-- Select Diagnosis  operating mode and start diagnosis.

-- Select the VIN.

-- Set V  and press Accept  to select "Work with guided fault finding".

-- Continue following the program procedure.

NOTE:

The following describes the control module identification and forwarding to the guided fault finding.

-- Select the Control modules  tab.

-- Select control modules and the Check DTC memory  function by right clicking on it to see faults stored in the DTC memory.

-- Continue following the program procedure.

-- Rectify the relevant errors after discussing them with the customer.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.