Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE
Overview - Control Module And Hydraulic Unit
- ABS Hydraulic Unit -N55- with ABS Control Module -J104-
- Installed location: in the front left engine compartment.
- Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLINGΒ .
- The hydraulic control unit consists of ABS Hydraulic Unit -N55- with integrated Brake Pressure Sensor 1 -G201- and the ABS Control Module -J104-.
- Do not disconnect the connector before successfully completing OBD.
- Switch the ignition off before disconnecting the connector.CAUTION:
ABS Hydraulic Unit -N55- and ABS Control Module -J104- must not be disconnected from each other.
- Bracket
- Cannot be removed.
- Connector
- For ABS Control Module -J104-
- Brake Line
- To the brake master cylinder
- Brake Line
- To the brake master cylinder
- Brake Lines
- Hydraulic unit to right front brake caliper
- Hydraulic unit to left front brake caliper
- Hydraulic unit to left rear brake caliper
- Hydraulic unit to right rear brake caliper
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
