2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE

Engine Control Module: Removing

-- If the engine control module is replaced, in "Guided Fault Finding  " select "Replace Engine Control Module  " to vehicle diagnostic tester.

-- Turn ignition off and remove the ignition key.

-- Remove nut -3- and bolt -2-.

Fig 1: Removing Filler Neck -1- With Filler Tube From Washer Fluid Reservoir & Opening In Body -Arrow-
GWWA92-10185Courtesy of AUDI OF AMERICA, LLC

-- Remove filler neck -1- with filler tube from the washer fluid reservoir and opening in the body -arrow-.

-- Remove bolts -arrows- and the cover from the E-box.

Fig 2: Identifying E-Box Bolts & Cover
GWWA10-10853Courtesy of AUDI OF AMERICA, LLC

-- Release retainers -A arrows- and remove ECM -J623- -arrow B-.

Fig 3: Engine Control Module (ECM)
GWWA10-10854Courtesy of AUDI OF AMERICA, LLC

To increase the difficulty with which the ECM connectors can be accessed, the ECM -1- is secured in a metal housing -5- with retaining tabs -2- and shear bolts -3 and 4-.

Fig 4: Identifying Engine Control Module (ECM) Components
GWWA24-0593Courtesy of AUDI OF AMERICA, LLC

The threads of the shear bolts -4- (that are not screwed into the ECM) are coated with a locking compound. For this reason, the threads must be heated with the heat gun to remove both bolts.

The threads of both shear bolts -3-, that are screwed into the ECM, are not coated with a locking compound. The threads in the ECM housing must not be heated and do not require to be heated (unintentional heating of the ECM).

Fig 5: Identifying Engine Control Module (ECM) Components
GWWA24-0593Courtesy of AUDI OF AMERICA, LLC

-- Set the adjustment on the heat gun as shown in the illustration, with the temperature potentiometer -2- set to maximum heat and the two-stage air flow switch -3- set to level 3.

Fig 6: Identifying Controls For Heat Gun
GWWA24-0476Courtesy of AUDI OF AMERICA, LLC
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.