2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE

Engine Control Module: Notes

Special tools and workshop equipment required 

  • Heat gun 220 V/50 Hz VAS1978/14 with nozzle attachment from wiring harness repair kit VAS1978
  • Small, commercially available locking pliers (vise grips)
NOTE:

The Engine Control Module (ECM) -1- is bolted to a protective housing -5-. To make removing the shear bolts -4- for the retaining tabs -2- more difficult, the threads are coated with locking compound.

Fig 1: Identifying Engine Control Module (ECM) Components
GWWA24-0593Courtesy of AUDI OF AMERICA, LLC

To disconnect the connectors from the ECM (for example to connect the test box or to replace the ECM), the metal housing must be removed.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.