2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE

Overview - Front Control Module

Fig 1: Overview Of Front Control Modules And Relay/Fuse Carriers
GWWA97-11861Courtesy of AUDI OF AMERICA, LLC
  1. E-Box
  2. Mount
    • For engine control module
  3. Engine Control Module
  4. Cover
    • For E-box
    • Tightening specification, refer to Figure
  5. Garage Door Opener Control Module -J530-
  6. Garage Door Opener Control Module -J530-
  7. Relay/Fuse Carrier Mount with Vehicle Electrical System Control Module -J519-
  8. Vehicle Electrical System Control Module -J519-
Fig 2: Installing Fuse Panel Mount
GWWA97-10457Courtesy of AUDI OF AMERICA, LLC
  1. Retaining pins
  2. Nuts - 3 Nm
  3. Relay/Fuse Panel Mount and Vehicle Electrical System Control Module -J519-
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.