Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE
Overview - Front Control Module
- E-Box
- Mount
- For engine control module
- Engine Control Module
- Cover
- For E-box
- Tightening specification, refer to Figure
- Garage Door Opener Control Module -J530-
- Vehicles through MY 2012
- Removing and installing, refer to Garage Door Opener Control Module -J530-, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2012
- Garage Door Opener Control Module -J530-
- Vehicles from MY 2013
- Removing and installing, refer to Garage Door Opener Control Module -J530-, REMOVING AND INSTALLING, VEHICLES FROM MY 2013
- Relay/Fuse Carrier Mount with Vehicle Electrical System Control Module -J519-
- Removing and installing, refer to RELAY/FUSE CARRIER MOUNT WITH Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING
- Vehicle Electrical System Control Module -J519-
- Removing and installing, refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING
- Retaining pins
- Nuts - 3 Nm
- Relay/Fuse Panel Mount and Vehicle Electrical System Control Module -J519-
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
