Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Audi Q5 3.2FACTORY OEM SERVICE PROCEDURE
Overview - Rear Control Module
- Comfort System Central Control Module -J393-
- Removing and installing, refer to Comfort System Central Control Module -J393-, REMOVING AND INSTALLINGΒ
- Nut
- 3 Nm
- Frame
- For Comfort System Central Control Module -J393-
- Parking Aid Control Module -J446-
- Overview, refer to OVERVIEW - PARKING AID .
- Frame
- For the control modules
- Special Purpose Vehicle Control Module -J608-
- In the luggage compartment on the left side
- Removing and installing, refer to Special Purpose Vehicle Control Module -J608-, REMOVING AND INSTALLINGΒ
- Electromechanical Parking Brake Control Module -J540-
- Removing and installing, refer to OVERVIEW - BATTERY COOLING MODULE .
- Cellular Telephone Amplifier -R86-
- Removing and installing, refer to Cellular Telephone Amplifier -R86-, REMOVING AND INSTALLING .
- Parking Heater Radio Receiver -R64-
- Removing and installing, refer to Parking Heater Radio Receiver -R64-, REMOVING AND INSTALLING
- Frame
- For the control modules
- Nut
- 3 Nm
- Towing Recognition Control Module -J345-
- Removing and installing, refer to Towing Recognition Control Module -J345-, REMOVING AND INSTALLING
- Nut
- 3 Nm
- Electronic Damping Control Module -J250-
- Removing and installing, refer to ELECTRONIC DAMPING CONTROL MODULE .
- Nut
- 3 Nm
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
