2012 Audi A8 BaseFACTORY OEM SERVICE PROCEDURE

Windshield Projection Head Up Display Control Module, Removing And Installing: Notes

CAUTION:

Danger of causing damage.

  • Remove only the marked screws from the Windshield Projection Head Up Display Control Module -J898-.
  • The Windshield Projection Head Up Display Control Module -J898- must be replaced if the screws are removed from the housing upper section.
  • If the Windshield Projection Head Up Display Control Module -J898- should fall down, it must be replaced because the inner components will get damaged even though there is no damage on the outside.
  • Do not place any force on the upper section of the Windshield Projection Head Up Display Control Module -J898- housing. Otherwise the Windshield Projection Head Up Display Control Module -J898- will have to be replaced.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.