Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Audi A7FACTORY OEM SERVICE PROCEDURE
Rear View Camera System Control Module -J772-, Connector Views, My 2016
- 8-pin connector -T8bg-
| T8bg (A) | Designation |
|---|---|
| 1 | Terminal 15, from Fuse Carrier 1 ST1 in Fuse panel SB |
| 2 | |
| 3 | |
| 4 | CAN bus Extended High, for B108 Connection 1 (CAN bus Extended High) in the main wiring harness |
| 5 | Terminal 31, to the 51 ground point in the trunk right |
| 6 | |
| 7 | |
| 8 | CAN bus Extended Low, for B109 Connection 1 (CAN bus Extended Low) from the main wiring harness |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
