2011 Audi A8 BaseFACTORY OEM SERVICE PROCEDURE

Instrument Cluster Multi-Pin Connector Contact Assignment

Gray 32-pin connector -A-

Fig 1: Identifying MOST Bus Connection
GWWA90-10145Courtesy of AUDI OF AMERICA, LLC
  1. Diagnostics for Data Bus On Board Diagnostic Interface -J533-
  2. CAN Bus Shield
  3. CAN Bus Instrument Cluster High
  4. CAN Bus instrument cluster Low
  5. Sensor Ground for All Fuel Level Sensors
  6. Fuel Level Sensor -G-
  7. Fuel Level Sensor -G-
  8. Instrument Cluster Operation Button -E493-
  9. Fuel Level Sensor 2 -G169-
  10. Fuel Level Sensor 2 -G169-
  11. Fuel Level Sensor 3 -G237-
  12. Fuel Level Sensor 3 -G237-
  13. Not Assigned
  14. Not Assigned
  15. Not Assigned
  16. Not Assigned
  17. Analog Clock -Y-
  18. Video Shield - Preparation Work
  19. Night Vision System Control Module -J853- "-"
  20. Night Vision System Control Module -J853- "+"
  21. Video Shield - Preparation Work
  22. Not Assigned
  23. Radio Frequency Controlled Clock 5 V - Preparation Work
  24. Radio Frequency Controlled Clock Signal - Preparation Work
  25. Not Assigned
  26. Not Assigned
  27. Not Assigned
  28. Not Assigned
  29. Terminal 31
  30. Terminal 31
  31. Terminal 30
  32. Terminal 30

Optical MOST-Bus connection (fiber optic) -B-

Fig 2: Identifying MOST Bus Connection
GWWA90-10145Courtesy of AUDI OF AMERICA, LLC
  1. MOST bus input
  2. MOST bus output
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.