Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rearview Camera System Control Module
A -
Black 54-pin connector (T54b)
B -
FBAS input (brown) from TV tuner -R78- (through 29 August 2008)
-
not assigned (from 1 September 2008)
C -
FBAS output (green) to front information display control head control module -J523- (through 29 August 2008)
-
FBAS output (green) to information electronics control module 1 -J794- (from 1 September 2008)
D -
FBAS input (gray) from rear view camera -R189-
Unlisted connector terminals are not assigned.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.