Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Audi A6 BaseFACTORY OEM SERVICE PROCEDURE
Timing Chain Guide: Remove & Replace
WARNING: This page is about the A6 Avant Quattro, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| V6,AWD, Camshaft,Both | 15.4 | B | ||
| V6,AWD, Camshaft,One Side | 15.1 | B | ||
| V6,AWD, Drive,Left | 13.9 | B | ||
| V6,AWD, Drive,Right | 13.6 | B | ||
| V6,AWD, Drive,Upper | 13.1 | B | ||
| V6,AWD, Power Take-off | 13.5 | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.