Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Audi A6 BaseFACTORY OEM SERVICE PROCEDURE
3.2L V6 4V Generic Scan Tool, Engine Code(S): BKH
- 20 - Fuel Supply System
- 24 - Multiport Fuel Injection
- Ignition System, Servicing
- Components, Checking
- Components, Checking
- Oxygen Sensor Heater before Catalytic Converter, Checking
- Oxygen Sensor Heater after Catalytic Converter, Checking
- Throttle Valve Control Module, Checking
- Engine Speed Sensor, Checking
- Intake Air Temperature Sensor, Checking
- Engine Coolant Temperature Sensor, Checking
- Fuel Pressure Sensor, Checking
- Low Fuel Pressure Sensor, Checking
- Fuel Metering Valve, Checking
- Intake Manifold Tuning Valve Position Sensor, Checking
- Intake Manifold Runner Control Valve, Checking
- Intake Manifold Runner Position Sensor 1, Checking
- Intake Manifold Runner Position Sensor 2, Checking
- Fuel Injectors, Checking
- Functions, Checking
- SIMOS Control Module
- Additional Signals, Checking
- 26 - Exhaust System, Emission Controls
- 28 - Ignition/Glow Plug System
- 38 - Automatic Transmission - Gears, Hydraulic Controls
- Transmission Regulating Electrical Components, Checking
- Transmission Regulating Electrical Components, Checking
- Safety Precautions
- Clean Working Conditions
- Multi-Function Transmission Range Switch, Checking
- Transmission RPM Sensor, Checking
- Transmission Output RPM Sensor, Checking
- Transmission Fluid Temperature Sensor, Checking
- Solenoid Valve 1, Checking
- Transmission Control Module
- Transmission Control Module Voltage Supply, Checking
- Transmission Control Module, Replacing
- Continuously Variable Transmission, Checking
- Transmission Regulating Electrical Components, Checking
- ST - Generic Scan Tool
- On Board Diagnostic
- Diagnostic Modes
- Diagnostic Modes
- Diagnostic Mode 01 - Obtain Data
- Diagnostic Mode 02 - Obtain Operating Conditions
- Diagnostic Mode 03 - Interrogating Fault Memory
- Diagnostic Mode 04 - Reset/Delete Diagnostic Data
- Diagnostic Mode 05 - Check Lambda Test Results
- Diagnostic Mode 06 - Checking Test Results of Components Not Continuously Monitored
- Diagnostic Mode 07 - Check Test Results of Continuously Monitored Components
- Diagnostic Mode 08 - Tank Leak Test
- Diagnostic Mode 09 - Vehicle Information
- Preliminary Check
- Readiness Code
- DTC Tables
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.