2006 Audi A4 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Technical data, ignition

IGNITION TECHNICAL DATA

Engine code AMB (1.8 L / 5V / 125 kW-Engine)
Idle speed
Engine speed cannot be adjusted, it is regulated by idle stabilization
700 to 860 RPM
Engine speed (RPM) limitation
Via fuel injector shut-off
approx. 6800 RPM
Ignition timing is determined in the control module
It is not possible to adjust the ignition timing
 
Ignition system Single coil ignition system with 4 ignition coils (power output stages integrated) that are connected directly to spark plugs via the ignition cables.
Spark plugs (1) Tightening torque 30 N.m
Ignition sequence  1-3-4-2
(1) Current values: See emissions test
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.