2006 Audi A4 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Safety precautions

To prevent injuries to persons and/or damage to the fuel injection and ignition system, the following must be noted:

  1. Do not touch or disconnect ignition wiring when the engine is running or at starter speed.
  2. Always switch off the ignition before connecting or disconnecting ignition system wiring. This also applies to HT cables and measuring instrument leads.
  3. To run engine at starting speed without actually starting it (for example, in order to test compression), remove connector from the power output stage of the ignition coils and also the connectors on the injectors.
  4. In the case of some tests, a malfunction may be recognized and stored by the control module. At the end of all tests and repairs, therefore, the DTC memory should be checked and, if necessary, erased. After erasing the DTC memory, generate a readiness code.
  5. Always switch off the ignition before washing the engine.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.