Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Audi TT Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| Convertible Top Fuse | On micro central electric panel. |
| Engine Compartment W-Box | At left rear of engine compartment. |
| Fuse Panel | Behind cover on left end of dash. |
| Main Fuse Box | Attached to top of battery. |
| Micro Central Electric Panel | Beneath left side of dash. |
| Power Window Circuit Breaker | On micro central electric panel. |
| 13-Fold Relay Panel | Beneath left side of dash, above micro central electric panel. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.