Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code Control Module (function 07)
- Connect the vehicle diagnostic, testing and information system VAS 5051. Refer to Vehicle diagnostic, testing and information system VAS 5051, connecting and selecting functions , and select the vehicle system "01 - Engine electronics" from the menu. When doing this the ignition must be on.
Display on VAS 5051:
- Select diagnosis function "07 - Code control module" from the menu -1-.
Display on VAS 5051:
1 - Enter code word
(figures up to 32767)
- Using the keypad -2-, enter the correct control module coding as shown in the coding table. Refer to Coding table .
Meaning of coding:
| XX | Country/emissions | |||
| X | Drive layout/additional functions | |||
| X | Gearbox | |||
| X | Model |
| Example of coding | |
| 07700 | USA LEV 1) (exhaust emissions standard), all wheel drive with traction control (ASR)/ESP 2), 5-speed manual gearbox, Audi TT |
1) LEV: abbreviation for low emissions vehicle
2) ASR: abbreviation for anti-slip regulation
- Confirm input with Q button
Display on VAS 5051:
1 - Coding is being performed.
- Wait until the next display appears.
Display on VAS 5051:
1 - Coding of vehicle system performed
2 - Control module identification with new coding
(previous coding in brackets)
- Press the ← button to exit from the diagnosis function "07 - Code control module"
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
