Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Audi S6FACTORY OEM SERVICE PROCEDURE
Implementing function "07 - Code Control Module"
Indicated on display:
Fig 1: V.A.G 1551 Scan Tool (ST) Display - Central Locking System, Code Control Module, Function 07 (1 Of 3)
- Press buttons -0- and -7-.
Indicated on display:
Fig 2: V.A.G 1551 Scan Tool (ST) Display - Central Locking System, Code Control Module, Function 07 (2 Of 3)
- Confirm entry with -Q- button.
Indicated on display:
Fig 3: V.A.G 1551 Scan Tool (ST) Display - Central Locking System, Code Control Module, Function 07 (3 Of 3)
- Use keypad to enter central locking control module code as per table:
In addition to basic coding, it is possible to offer the following option:
- Vehicle automatically locks upon reaching a speed of about 15 km/h (10 mph) and unlocks when key is removed from ignition.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.