2002 Audi A6 BaseFACTORY OEM SERVICE PROCEDURE

Technical data

TECHNICAL DATA SPECIFICATIONS

Engine code AVK (3.0 Liter / 5V /162 kW engine)
Idling speed (Not adjustable - controlled by the idling speed stabilization)
Manual transmission 700 to 800 rpm
Automatic transmission Front Wheel Drive (FWD) 670 to 770 rpm (1)
Automatic transmission All Wheel Drive (AWD) 630 to 730 rpm
Engine speed limitation (Shuts off injectors) approx. 6800 rpm
Ignition timing is determined by the control module. Ignition timing cannot be adjusted.
Ignition system Individual coil system with 6 ignition coils (output stages integrated) connected directly to spark plugs via spark plug connectors
Spark plugs Tightening torque 30 Nm
Firing order 1-4-3-6-2-5
(1) Depending on engine oil temperature / transmission oil temperature (automatic transmission 01J), an engine speed increase up to 980 rpm is possible.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.