Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Audi S4 Quattro, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel System Pressure
- Ensure fuel pump relay is okay. Ensure correct fuel filter is installed. Ensure battery voltage is at least 12 volts. Release fuel pressure. See FUEL PRESSURE RELEASE .
- Connect Pressure Gauge (VAG 1318) between fuel supply and fuel return lines in engine compartment. See Fig 1 . Disconnect and plug vacuum line from fuel pressure regulator. Start engine, and let idle. Fuel pressure should be within specification. See appropriate FUEL PRESSURE SPECIFICATIONS table.
- If fuel pressure is within specification, connect vacuum hose to fuel pressure regulator. Pressure should drop as specified. See appropriate FUEL PRESSURE SPECIFICATIONS table. If fuel pressure is not within specification, check fuel pressure regulator, fuel pump and fuel lines and repair or replace as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.