2000 Audi TT QuattroFACTORY OEM SERVICE PROCEDURE

Computer Relearn Procedures

NOTE: These procedures must be performed after battery has been disconnected and reconnected.

After reconnecting battery, turn ignition on. Wait 5 seconds before starting engine. To reactivate one-touch-up and one-touch-down power window feature, close window by lifting and holding power window switch. After window is closed, release switch then lift again for one second. To recode radio, see radio operating instructions.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.