Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Audi S4 AutomaticFACTORY OEM SERVICE PROCEDURE
Power Window One-Touch Feature
WARNING: This page is about a different car, the 2003 Audi allroad, 2003 Audi TT, 2003 Audi S6, 2003 Audi A6, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
If the vehicle battery is disconnected and then reconnected, the automatic closing and opening function will not work until it is reactivated. To reactivate this feature, perform following steps:
- Close the window completely by lifting and holding the power window switch.
- Release the switch and then lift the switch again for one second. Automatic closing/opening is now activated.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.