Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Audi A6 BaseFACTORY OEM SERVICE PROCEDURE
Test sequence
- Connect VAS5051 tester or VAG1551 scan tool and select control module for engine electronics using "address word" 01. See VAS 5051 VEHICLE DIAGNOSTIC, TESTING AND INFORMATION SYSTEM OR VAG1551 SCAN TOOL (ST), CONNECTING AND SELECTING FUNCTIONS
.
Engine must run at idle for this.
When indicated on display:
- Press buttons -0- and -8- to select "Read measuring value block" function 08. Press -Q- button to confirm input.
When indicated on display:
- Press buttons -0-, -1- and -4- to select "display group number 014" and press -Q- button to confirm input.
When indicated on display:
- Check misfire recognition in display fields 3 and 4.DISPLAY GROUP 014: MISFIRE RECOGNITION
Display fields 1 2 3 4 Display group 014: Misfire recognition Display xxxx/min xxx% xxx --- Indicated Engine speed (RPM) Load Number of combustion misfires Misfire recognition Functional range 670 to 6800 RPM 12 to 100% activated locked Specified value 720 to 820 RPM (1) 12 to 26% 0 to 12 activated 670 to 770 RPM (2) Notes If the specified value is exceeded: Check combustion misfires of the individual cylinders . See CHECKING MISFIRE RECOGNITION OF INDIVIDUAL CYLINDERS . (1) Front Wheel Drive Vehicles (2) All-Wheel Drive Vehicles
If specified value is obtained:
- Press -->button.
Indicated on display (function selection):
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.