Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Audi A6 BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Motors
MOTORS
| Component | Component Location |
|---|---|
| ABS Return Flow Pump | Part of ABS/EDL hydraulic unit. |
| Airflow Flap Motor/Position Sensor | Near blower motor fresh air intake. |
| Central Air Flap Motor/Position Sensor | On right side of evaporator housing. |
| Cruise Control Vacuum Pump | Left side of engine compartment. See Figure. |
| Defroster Flap Motor/Position Sensor | On right side of evaporator housing. |
| Fresh Air Blower | Behind right side of dash. |
| Fuel Pump | In fuel tank. |
| Fuel Tank Lid Unlock Motor | On right side of luggage compartment. See Figure. |
| Leak Detection Pump (LDP) | At back of left rear wheelhousing. |
| Secondary Air Injection (AIR) Pump Motor | Right front corner of engine compartment. |
| Temperature Flap Actuator/Potentiometer (Left) | On left side of evaporator housing. |
| Temperature Flap Actuator/Potentiometer (Right) | On right side of evaporator housing. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
