Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Audi A6 BaseFACTORY OEM SERVICE PROCEDURE
Rear Doors
- Rear doors
- Rear door and door component carrier, removing and installing
- Window regulator and door window, removing and installing
- Rear door window, adjusting
- Rear door, adjusting
- Window regulator motor, removing and installing
- Rear door handle and door lock, assembly overview
- Door lock, removing and installing
- Rear door handle, removing
- Rear door handle, pre-assembling
- Door seal, removing and installing
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
