2000 Audi A6 BaseFACTORY OEM SERVICE PROCEDURE

Window Switches: A4

  1. Remove window switch to be tested and disconnect harness connector. Check continuity between switch terminals with switch in appropriate position. See POWER WINDOW SWITCH TESTΒ  table. See Fig 1 . If continuity is not as specified, replace window switch.
  2. After installation of new components or disconnecting and reconnecting battery, run power window to fully closed position. Release switch. With window fully closed, press switch in up position again for one second. This will reactivate the "express" feature.
POWER WINDOW SWITCH TEST

Switch Position Check For Continuity Between Terminals No.
Up 1 & 4
Neutral (1) 2 & 5; 1 & 3
Down 2 & 4
(1) No continuity should exist between terminals No. 2 and 4, and terminals No. 1 and 4.
Fig 1: Identifying Power Window Switch Terminals
G97F11481Courtesy of AUDI OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.