Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Safety Lockout Switch: A4
Remove safety lock-out switch and disconnect harness connector. Check continuity between switch terminals with switch in appropriate position. See SAFETY LOCK-OUT SWITCH TEST table. See Fig 1 . If continuity is not as specified, replace safety lock-out switch.
| Switch Position | Check Continuity Between Terminals No. | Specification |
|---|---|---|
| Off | 2 & 3 | No Continuity |
| On | 2 & 3 | Continuity |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.