2000 Audi A4 Base, 1.8 C, StandardFACTORY OEM SERVICE PROCEDURE

Engine Controls - Service & Adjustment Specifications: Capacities

CAUTION: When battery is disconnected, radio will go into anti-theft protection mode. Obtain radio anti-theft protection code from owner prior to servicing vehicle.
FLUID CAPACITIES

Application Quantity
Crankcase (Includes Filter) (1)
1.8L Turbo 3.7 Qts. (3.5L)
2.8L 6.3 Qts. (6.0L)
Cooling System (Includes Heater)
A4
1.8L Turbo 7.4 Qts. (7.0L)
2.8L 6.4 Qts. (67.0L)
Automatic Transmission
Initial Fill
A4(2) 9.5 Qts. (9.0L)
Fluid Change
A4(3) (4) 2.7 Qts. (2.6L)
Final Drive (Differential)
Front Differential
Initial Fill
A4 (SAE 75W-90 Synthetic) .84 Qt. (.8L)
Fluid Change
A4 (SAE 75W-90 Synthetic) .79 Qt. (.75L)
Center Differential
Initial Fill (SAE 75W-90 Synthetic)
A4 Quattro .84 Qt. (.8L)
Fluid Change (SAE 75W-90 Synthetic)
A4 Quattro .79 Qt. (.75L)
Rear Differential
Initial Fill (SAE 90W)
A4 Quattro 2.0 Qts. (1.9L)
Fluid Change (SAE 90W)
A4 Quattro 1.9 Qts. (1.8L)
Manual Transmission (SAE 75W-90 Synthetic)
A4 2.9 Qts. (2.7L)
Power Steering (5)
A4 12-15 oz. (.7-.9L)
(1) To prevent overfilling, add approximately 1/2 qt. less than capacity. Start engine. Run until operating temperature is reached. Turn ignition off. Wait about 3 minutes. Check oil level. Fill to FULL mark on dipstick. Additional oil may be more or less than 1/2 quart.
(2) Use fluid ESSO EGL 71141. Color is Yellow. DO NOT use additives.
(3) Use fluid part No. G-052-162-A2. Color is Yellow/Gold. DO NOT use additives.
(4) Fluid change capacity is up to 3.7 qts. if pan is removed.
(5) DO NOT use Dexron ATF.
Chapter Navigation
Return to Chapter: Engine Controls - Service & Adjustment Specifications
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.