1998 Audi CabrioletFACTORY OEM SERVICE PROCEDURE

Intermittent Failures

When an intermittent failure occurs, MIL comes on and a Diagnostic Trouble Code (DTC) sets. Powertrain Control Module (PCM) stores DTC as sporadic. Intermittent (sporadic) failures will be erased by PCM if failure does not occur again within 40 engine starts on Cabriolet, or after 50 engine starts with engine reaching operating temperature on 1.8L and 2.8L (except Cabriolet). Intermittent failures may be caused by problems with a sensor, connector or wiring. See INTERMITTENTS in TESTS W/O CODES article.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.