1998 Audi CabrioletFACTORY OEM SERVICE PROCEDURE

Fuel Pump: Notes

WARNING: Before removing fuel pump or sensor, ensure that fuel tank is less than 1/4 full. Failure to do so will result in large quantities of fuel being spilled. DO NOT smoke or work near heaters or anything that might spark and ignite fuel. Clean area and connectors around fuel pump access, and release fuel pressure before removing fuel pump.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.